Create a DNP3 SCADAPack E Direct Outstation

When you create the outstation, most of the configuration fields can be left at their default values. The only fields you need to change for this tutorial are:

For further information on configuring a DNP3 SCADAPack E Direct Outstation, see Configuring DNP3 SCADAPack E Outstations.

ClearSCADA will raise a Communication State - Failed alarm when you save the outstation’s configuration, as the outstation is not powered up.

Once you have configured the outstation in ClearSCADA, you can proceed to Create a DNP3 SCADAPack Analog Output Point.


Disclaimer

ClearSCADA 2017 R2