Add a DNP3 Route

You add a DNP3 route for the SCADAPack device to send unsolicited events to the Geo SCADA Expert server. 

To add a DNP3 route, do the following:

1. Right-click the SCADAPack 575 Device Configuration item and select Edit Tables.
   The table editor window is displayed.
2. Select the Add DNP3 Route button.
3. Set the Source Port to Any Port.
4. Set the Source Start address and the Source End address to 0 to match the same address that you entered for the DNP3 Outstation Address earlier in this tutorial.
5. Set the Destination Start address and the Destination End address to 30000 to match the same address that you entered for the DNP3 Controlling Station Address earlier in this tutorial.
6. Set the Destination Port to Ethernet 1.
7. Set the Connect Number to match the IP address of the Geo SCADA Expert server.
8. Set the Routing Status to On Static.
9. Select the OK button to add the DNP3 route to the table.
10. Save the configuration.

After adding the DNP3 route to the SCADAPack 575 device, you can proceed to Create an Analog Configuration Item.